Replacing an AquaSpy Solar Panel

Replacing an AquaSpy Solar Panel 

Steps

1. Undo the 6 screws on the back of the Comm Tower (CT)
2. Open the box (i.e. lift off the solar panel) carefully. It will probably be reasonably well sealed and you should gently pry the solar panel from the lower unit.
3. Locate the solar planel and undo the white clip attaching it to the main circuit board
4. Connect new solar panel
5. Close the lid, making sure not to pinch either the battery or solar panel wires under the lid.
6. Screw the box closed by tightening opposite screws in turn, like lug nuts on a wheel. This will ensure the lid seals evenly. Don’t over tighten the screws as you may strip the threads and/or damage the seal. Screws should be firm but not tight.
7. The old solar panel can be discarded, and the CT can be powered up.

Please contact FarmQA Support with any further questions